1. Since construction machinery is a special vehicle, operators should receive training and guidance from the manufacturer before operating the machine, fully understand the structure and performance of the machine, and gain certain operation and maintenance experience. The "Product Use and Maintenance Instructions" provided by the manufacturer are essential information for operators to operate the equipment. Before operating the machine, be sure to read the "Use and Maintenance Instructions" and perform operation and maintenance as required.
2. Pay attention to the workload during the running-in period. Half of the working load during the running-in period should not exceed 60% of the rated working load, and appropriate working loads must be arranged to prevent overheating caused by long-term continuous operation of the machine.
3. Pay attention to the instructions of each instrument frequently. If there is any abnormality, stop the machine immediately and eliminate it. Operation should be stopped until the cause is identified and the fault is not eliminated.
4. Pay attention to frequently checking the level and quality of lubricating oil, hydraulic oil, coolant, brake fluid, and fuel (water), and pay attention to checking the sealing of the whole machine. Excess oil and water are found during inspection, and the cause should be analyzed. At the same time, the lubrication of each lubrication point should be strengthened. It is recommended to add grease to the lubrication points of each shift during the running-in period (except for special requirements).
5. Keep the machine clean, adjust and tighten loose parts in time to prevent loose parts from aggravating wear or causing parts to be lost.
Post time: Sep-15-2023